1/26/2024 0 Comments U boot splashSpi_loadsplash=sf probe sf read $ commands. Splash image in NOR SPI flash U-Boot variables loadsplash=run spi_loadsplash In Linux kernel boardfiles there's a machine structure. Most of these functions don't get called from within the boardfile. For example boardmmcinit (), enetboardinit (), setupsplashimg (), etc. splashpos: image position (eg: splashpos=m,m, for centering the image) I'm looking at a u-boot boardfile, and it has many functions in it.If you want Linux to keep your U-Boot Logo during boot process, then some tweaks are needed: define. This command is automatically run by U-Boot at startup How To Change Ubuntu Boot Splash Screen In Plymouth. loadsplash: comand for loading the BMP image from the storage device (e.g flash memory) to RAM.Please note that it must be a 32-bit aligned address with a 0x2 offset (eg: 0x20000002) splashimage: RAM address where the BMP image is loaded.The following U-Boot environment variables are required: As mentioned earlier the splash screen displayed by the uboot is maintained by the kernel only till DRM device gets configured by userspace application. To have u-boot load kernel image, set in your nf. The splash screen image should be a 24 bpp BMP file.įor further details on splash screen support in U-Boot, please refer to:Ĭustomizing the splash screen By default a rainbow splash screen is shown after the GPU firmware is loaded. The following sections describe how to use this feature. Albania Algrie American Samoa Andorra Angola Anguilla Antigua and Barbuda Armenia Argentina Aruba Australia Christmas Island Cocos (Keeling). Starting from version 2013.04-xelk-2.2.0, U-Boot for Axel SOMs provides support for a customizable splash screen. A splash screen is enabled by default, and is shown on the LVDS LCD. Using U-Boot 2019.07-3.0. + gd->fb_base = msg_setup->allocate_ Version + panel_info.cmap=malloc(256 * NBITS(panel_info.vl_bpix) / 8) gd->fb_base = msg_setup->allocate_address ![]() So the cmap is fill at 0x0 and lot’s of essential data like device tree too (at 0x100) is overwritten. The panel_info.cmap is not allocated and have a NULL value. If you want use the Splash screen of bitmap display in bootmap, there is a bug in the video driver. Hi a little (headache) contributed from me: ![]() One of the replies written in this thread suggests that raspberry pi’s default address configuration is messed up in a way that the display driver will corrupt other critical memory regions whenever it will try to show something up on the display. raspberry display related address is messed up In order to this to work properly, one must also turn on other ‘CONFIG_’s as well.Ģ. One must manually add ‘CONFIG_CMD_BMP’ configuration.įurther digging suggested that enabling ‘CONFIG_CMD_BMP’ alone is not enough. However, this command is not included in the default uboot. Apparently, this is the command that will display a bmp image file to the display. I think there are two problems that I should tackleįrom various uboot splashscreen tutorials, most of them utilize a ‘bmp’ command. The failure with displaying a picture on the display with uboot seems to be a complicated matter. To disable the splash screen, enter the following in the U-Boot command line interface: > run disablesplash > saveenv & reset And to re-enable it: > run enablesplash > saveenv & reset The splash image is taken from /boot/splash.bmp in the root file system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |